2017 Super Products Supersucker Pneumatic Unloading

Supersucker industrial vacuum loaders can be equipped with a pneumatic unloading option to discharge virtually any dry material from the body into a silo, storage hopper, truck or storage containers. Unloading is accomplished by connecting the air conveying line from the vacuum pump exhaust piping to the discharge port of the auger on the tailgate. Raising the collector body allows the auger to meter material through its discharge port into the pressurized conveying line. Pneumatic unloading cannot occur during the loading operation.

The discharge ducting and pneumatic conveying lines can be easily connected from ground level. A 6 (152.4 mm) diameter hose with Camlock fittings to connect the tailgate discharge Tee to the vacuum pump discharge piping is included with the unit.

The velocity of conveying air can be controlled by adjusting the speed of the vacuum pump. Light or fragile materials are conveyed at low speeds and heavier materials at higher speeds. The auger speed can be controlled to increase or decrease the amount of material metered from the body. Auger rotation is reversible. A pressure gauge is provided to indicate optimum operational conditions. All controls are located at the Supersucker control panel.

The auger is an integral part of the tailgate and does not interfere with normal machining functions. The operator can choose to dump recovered material in the conventional manner or discharge material pneumatically through the auger system to a remote location. If needed the the auger can also meter material from the body without pneumatic conveying. The 9? (228.6 mm) diameter auger is double flighted to pull material from both sides toward the center discharge port. The auger shaft is supported by anti-friction bearings and seals.

The auger is driven by a low speed high torque hydraulic motor using a fully enclosed chain and sprocket arrangement. Hydraulic power is obtained from the Supersucker hydraulic system. Auger speed is controlled by an adjustable hydraulic flow valve.

When conveying pressure reaches a predetermined level the unloading system will automatically vent, protecting the system.

The airflow initiates from the vacuum pump discharge silencer and continues to the discharge port of the auger. Connections are easily accomplished from ground level with Camlok fittings.

The vacuum pump is protected by a pressure relief system which vents in the event of a plugged discharge line, plugged filter at the receiving site or an attempt to convey too large an amount of material.

• 35 (10.67 m) approximate overall length

• 1210 (3.91 m) approximate overall height

• 8 (2.44 m) approximate overall width

• 8 (20.3 cm) positive displacement vacuum system offers 5800 cfm/28 hg (9854 m3 /hr/0.95 bar)

• Heavy-duty transfer case drive

• Single mode filtration enables loading of wet or dry material with no changeover required

• Reverse air pulsation system continuously cleans the 60 snap-ring type, acrylic-coated filter bags

• Easy filter access on top of unit for filter bag change-out; large side door access to baghouses allows for quick bag removal

• One large cyclone with large passageways for greater airflow, greater performance and greater fuel economy